Lantronix XPress-Pro SW 52000 XPress-Pro SW - 94000 User Guide - Page 20
Connecting to Your Network, Cable Type & Length
View all Lantronix XPress-Pro SW 52000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
3: Installation A host system is running a terminal emulation program that supports the Kermit file transfer protocol. The host system's hard drive has the required binary file that will be downloaded to the Xpress-Pro SW 94000 switch. Configure the system This option lets you modify any configurable parameter in the switch's flash ROM before the Xpress-Pro SW 94000 switch system boots. Run manufacturing diagnostics This option is to download the manufacturer's diagnostics. Refer to Download Runtime Software for download requirements. When the file transfer is completed, the target system jumps to the entry point of the diagnostic program and starts executing the diagnostic code. The Main Menu of the diagnostic program appears where you can initiate tests or obtain system information. Note that user intervention is not required when a test runs, unless an error occurs. If an error occurs during testing, you are given the choice of continuing the diagnostics or skip the error. Connecting to Your Network Cable Type & Length It is necessary to follow the cable specifications below when connecting the Xpress-Pro SW 94000 switch to your network. Use appropriate cables that meet your speed and cabling requirements. Speed 10BaseT 100BaseTX 1000BaseT 100BaseFX 100BaseFX 1000BaseSX 1000BaseLX Connector RJ-45 RJ-45 RJ-45 ST, SC ST, SC SC SC Cable Specifications Port Speed Cable Half/Full Duplex 10/20 Mbps 2-pair UTP/STP Cat. 3, 4, 5 100/200 Mbps 2-pair UTP/STP Cat. 5 2000 Mbps 4-pair UTP/STP Cat. 5 100/200 Mbps MMF (50 or 62.5µm) 100/200 Mbps SMF (9 or 10µm) 2000 Mbps MMF (50 or 62.5µm) 2000 Mbps SMF (9 or 10µm) Max. Distance 100 m 100 m 100 m 2 km 15, 40, or 75 km 550 m 10, 20, or 60 km XPress-Pro SW 94000 User Guide 20