Lenovo 9960AKU Hardware Maintenance Manual - Page 64
PCI Card Test Passed, PCI Card Failure
UPC - 884942572920
View all Lenovo 9960AKU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Diagnostic Error Code FRU/Action 015-035-XXX USB port Reset condition detected 1. Remove USB device(s) and re-test 2. System board 015-036-XXX USB port Register error System board 015-040-XXX USB port IRQ failure 1. Run setup and check for conflicts 2. Flash the system. See "Updating (flashing) BIOS from a disc" on page 560 3. System board 015-195-XXX USB port Test aborted by user Information only Re-start the test, if necessary 015-196-XXX USB port test halt, error threshold exceeded 1. Press F3 to review the log file 2. Re-start the test to reset the log file 015-197-XXX USB port test warning 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6 "Using the Setup Utility" on page 43 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 015-198-XXX USB port test aborted 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6 "Using the Setup Utility" on page 43 2. Flash the system and re-test. See "Updating (flashing) BIOS from a disc" on page 560 3. Go to "Undetermined problems" on page 69 015-199-XXX USB port test failed, cause unknown 1. Go to "Undetermined problems" on page 69 2. Flash the system and re-test. See "Updating (flashing) BIOS from a disc" on page 560 3. Replace component under function test 018-000-XXX PCI Card Test Passed No action 018-0XX-XXX PCI Card Failure 1. Riser card, if installed 2. System board 018-195-XXX PCI Card Test aborted by user 1. PCI card 2. Information only Re-start the test, if necessary 018-196-XXX PCI Card test halt, error threshold exceeded 1. Press F3 to review the log file 2. Re-start the test to reset the log file 018-197-XXX PCI Card test warning 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6 "Using the Setup Utility" on page 43 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 56 ThinkCentre Hardware Maintenance Manual