Lenovo H230 Lenovo 3000 H Series Hardware Replacement Guide V2.0 - Page 22

Replacing the keyboard

Get Lenovo H230 - Desktop 4GB 1TB HDD PDF manuals and user guides
UPC - 884942470844
View all Lenovo H230 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

6. Slide the new optical drive into the bay from the back until it snaps into position. 7. Screw back the two screws on the bay. 8. Connect the data and power cables to the drive. 9. Install the front bezel. Refer to "Removing and replacing the front bezel". 10. Refer to the "Completing the installation". Replacing the keyboard Attention Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com To replace the keyboard: 1. Before removing any media (diskettes, CDs, or memory cards) from the drives, shut down your operating system, and turn off all attached devices and the computer. 2. Unplug all power cords from electrical outlets. 3. Locate the connector for the keyboard. Refer to "Locating connectors on the rear of the computer" and "Locating connectors on the front of the computer". Note: Your keyboard might be connected to the standard keyboard connector at the rear of the computer or to a USB connector at either the front or rear of the computer. 4. Disconnect the failing keyboard cable from the computer and connect the new keyboard cable to the same connector. Hardware Replacement Guide 19 31039394_3000 H_HRG_EN_V2.0.indd19 19 2009.7.14 4:15:54 PM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
±¹
Hardware Replacement Guide
6.
Slide the new optical drive into the bay from the back until it snaps into
position.
7.
Screw back the two screws on the bay.
8.
Connect the data and power cables to the drive.
9.
Install the front bezel. Refer to “Removing and replacing the front bezel”.
10. Refer to the “Completing the installation”.
Replacing the keyboard
Attention
Do not remove the computer cover or attempt any repair before reading the
“Important safety information” in the
Safety and Warranty Guide
that was
included with your computer or in the
Hardware Maintenance Manual
(HMM)
for the computer. To obtain copies of the
Safety and Warranty Guide
or
HMM
, go to the Support Web site at
To replace the keyboard:
1.
Before removing any media (diskettes, CDs, or memory cards) from the drives,
shut down your operating system, and turn off all attached devices and the
computer.
2.
Unplug all power cords from electrical outlets.
3.
Locate the connector for the keyboard. Refer to “Locating connectors on the
rear of the computer” and “Locating connectors on the front of the computer”.
Note:
Your keyboard might be connected to the standard keyboard
connector
at the rear of the computer or to a USB connector
at either
the front or rear of the computer.
4.
Disconnect the failing keyboard cable from the computer and connect the new
keyboard cable to the same connector.
31039394_3000 H_HRG_EN_V2.0.indd19
19
2009.7.14
4:15:54 PM