Lenovo IdeaCentre K220 IdeaCentre K220 Hardware Replacement Guide - Page 23

Replacing a memory module

Get Lenovo IdeaCentre K220 PDF manuals and user guides View all Lenovo IdeaCentre K220 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Replacing a memory module Attention Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at: http://consumersupport.lenovo.com To replace a memory module: 1. Remove the computer cover. Refer to "Removing the computer cover". Note: For this procedure, it helps to lay the computer on its side. 2. Locate the memory module connectors. Refer to "Locating components". 3. Remove the memory module being replaced by opening the retaining clips as shown. 4. Position the new memory module over the memory connector. Make sure the notch on the memory aligns correctly with the connector key on the system board. Push the memory module straight down into the connector until the retaining clips close. 5. Refer to the "Completing the installation". 20 Hardware Replacement Guide 31036127 IdeaCentre K_HRG_EN.indd 20 2008.10.20 1:59:36 PM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
20
Hardware Replacement Guide
Replacing a memory module
Attention
Do not remove the computer cover or attempt any repair before reading the
“Important safety information” in the
Safety and Warranty Guide
that was
included with your computer or in the
Hardware Maintenance Manual
(HMM)
for the computer. To obtain copies of the
Safety and Warranty Guide
or
HMM
, go to the Support Web site at:
To replace a memory module:
1.
Remove the computer cover. Refer to “Removing the computer cover”.
Note:
For this procedure, it helps to lay the computer on its side.
2.
Locate the memory module connectors. Refer to “Locating components”.
3.
Remove the memory module being replaced by opening the retaining clips as
shown.
4.
Position the new memory module over the memory connector. Make sure
the notch
on the memory aligns correctly with the connector key
on the
system board. Push the memory module straight down into the connector
until the retaining clips close.
5.
Refer to the “Completing the installation”.
3
036
27 I
aC
t
K
HRG
E
20
2008
0 20
:59:36 PM