Lenovo J100 Notice to New Zealand Users - Page 1
Lenovo J100 Manual
View all Lenovo J100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Notice to New Zealand Users Conexant RD01-D850 Data Fax PCI Modem - PTC 211/03/066 1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it imply that any product is compatible with all of Telecom's network services. 2. This equipment is not capable, under all operating conditions, of correct operation at the higher speeds for which it is designed. Telecom will accept no responsibility should difficulties arise in such circumstances. This condition typically applies to 56 kbit/s modems. 3. This equipment does not fully meet Telecom's impedance requirements. Performance limitations may occur when used in conjunction with some parts of the network. Telecom will accept no responsibility should difficulties arise in such circumstances. 4. The equipment shall not be set up to make automatic calls to Telecom's 111 Emergency Service. 5. This device may be subject to ringing or bell tinkle when certain other devices are connected to the same line. If this occurs, the problem should not be referred to the Telecom Faults Service. 6. This equipment should not be used under any circumstances that may constitute a nuisance to other Telecom customers. 7. Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the application software. The application software shall be set to operate within the following limits for compliance with Telecom's specifications: v The S0 register must contain a value of 0 for no auto-answer or a value of 3 to 8 for auto answer. The factory default is 3. v The S6 register must contain a value of 4, 5, 6 or 7. The factory default of 4 is recommended. v The S7 register must contain a value of less than 80. The factory default is 60. v The S10 register must contain a value of less than 140. The factory default is 14. v The S11 register must contain a value of greater than 60. The factory default is 85. v There shall be no more than 10 call attempts to the same number within any 30-minute period for any single manual call initiation. v The equipment shall go on-hook for a period of not less than 30 seconds between the end of one call attempt and the beginning of the next attempt to the same number. v Automatic calls to different numbers shall be not less than 2 seconds apart. v Failure to set these parameters correctly could negate the User Rights under the Telecom Terms of Service.