Lenovo K200 K200 User's Guide - Page 10

Chassis Side Lock, Audio Line-in Connector, Audio Line-out Connector, Microphone Jack, Voltage,

Page 10 highlights

--- Chassis Side Lock: After installing the side panel of the chassis, push the lock upward to lock the side panel in place. To remove the side panel, depress the lock first. --- Audio Line-in Connector: To connect audio input to the computer. - Audio Line-out Connector: To connect to the speakers or headphones. ---- Microphone Jack: To connect to audio input from a microphone. ---- Used to attach your computer to a telephone line for modem use. (some models equipped with this connector) --- Used to attach a telephone line to your computer. (some models equipped with this connector) -- Voltage: selection switch (Some models are equipped with this switch) Check the position of the voltage-selection switch on the rear of the computer. Use a ballpoint pen to slide the switch, if necessary. 1. If the voltage supply range is 100-127 V ac, set the switch to 115 V. 2. If the voltage supply range is 200-240 V ac, set the switch to 230 V. 115 230 Figure 1 31032754_IdeaCentre K UG_EN.indd 5 Figure 2 User Guide 5 2007.11.30 5:56:36 PM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39

5
User Guide
———
Chassis Side Lock:
After installing the side panel of the chassis,
push the lock upward to lock the side panel in place. To remove the
side panel, depress the lock first.
———
Audio Line-in Connector:
To connect audio input to the computer.
Audio Line-out Connector:
To connect to the speakers or
headphones.
————
Microphone Jack:
To connect to audio input from a microphone.
————
Used to attach your computer to a telephone line for modem use.
(some models equipped with this connector)
———
Used to attach a telephone line to your computer. (some models
equipped with this connector)
—— Voltage
:
selection switch (Some models are equipped with this
switch)
Check the position of the voltage-selection switch on the rear of the computer. Use
a ballpoint pen to slide the switch, if necessary.
1.
If the voltage supply range is 100-127 V ac, set the switch to 115 V.
2.
If the voltage supply range is 200-240 V ac, set the switch to 230 V.
115
230
Figure 1
Figure 2
3
032754
I
a
t
K
G
E
5
2007
30
5:56:36 PM