Lenovo K330B Lenovo IdeaCentre K330B Hardware Replacement Guide V5.0 - Page 40

Replacing the external speaker, Completing the installation - user manual

Get Lenovo K330B PDF manuals and user guides View all Lenovo K330B manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

Replacing the external speaker 1. Remove any media (diskettes, CDs, or memory cards) from the drives, shut down the computer, and turn off all attached devices. 2. Unplug all power cords from electrical outlets. 3. Locate the Speaker. Refer to "Locating connectors on the rear of the computer" and "Locating connectors on the front of the computer". Your speaker may be connected to the audio connector at either the front or rear of the computer. Locate the connector for the speaker. 4. Disconnect the defective speaker cable from the computer and connect the new speaker cable to the same connector. Completing the installation After replacing a new part or parts, you will need to close the computer cover and reconnect all cables, including telephone lines and power cords. In addition, depending on the part that was replaced, you may also need to confirm the updated information in the Setup Utility program. Refer to "Starting the Setup Utility" in the User Guide or in the Hardware Maintenance Manual for further information. To complete the part installation: 1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left inside your computer. Refer to "Locating components and connectors". 2. Make sure that all cables are routed correctly before replacing the computer cover. 3(7 &/ 3 JOEE Hardware Replacement Guide 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
37
Hardware Replacement Guide
Replacing the external speaker
1.
Remove any media (diskettes, CDs, or memory cards) from the drives, shut
down the computer, and turn off all attached devices.
2.
Unplug all power cords from electrical outlets.
3.
Locate the Speaker. Refer to “Locating connectors on the rear of the
computer” and “Locating connectors on the front of the computer”. Your
speaker may be connected to the audio connector
at either the front or rear
of the computer. Locate the connector for the speaker.
4.
Disconnect the defective speaker cable from the computer and connect the
new speaker cable to the same connector.
Completing the installation
After replacing a new part or parts, you will need to close the computer cover
and reconnect all cables, including telephone lines and power cords. In addition,
depending on the part that was replaced, you may also need to confirm the
updated information in the Setup Utility program. Refer to “Starting the Setup
Utility” in the
User Guide
or in the
Hardware Maintenance Manual
for further
information.
To complete the part installation:
1.
Ensure that all components have been reassembled correctly and that no tools
or loose screws are left inside your computer. Refer to “Locating components
and connectors”.
2.
Make sure that all cables are routed correctly before replacing the computer
cover.
31048526 IC K3 HRG V5.0 (EN)(R).indd
37
2011-3-14
17:34:19