Lenovo K450 IdeaCentre K4 Series Hardware Maintenance Manual - Page 33

Replacing a hard disk drive

Get Lenovo K450 PDF manuals and user guides View all Lenovo K450 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

Step 4. Position the new memory module over the memory connector. Make sure that the notch 1 on the memory module aligns correctly with the connector key 2 on the system board. Push the memory module straight down into the connector until the retaining clips close. Step 5. Reattach the computer cover. Replacing a hard disk drive Note: For this procedure, it helps to lay the computer flat. To replace a hard disk drive: Step 1. Step 2. Step 3. Remove the computer cover. Refer to "Removing the computer cover". Disconnect the data and power cables from the hard disk drive. Lift up the plastic handle and slide the hard disk drive out of the drive bay. 1 2 1 2 Chapter 8. Replacing hardware 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
Step 4.
Position the new memory module over the memory connector. Make sure that the notch
1
on the
memory module aligns correctly with the connector key
2
on the system board. Push the memory
module straight down into the connector until the retaining clips close.
Step 5.
Reattach the computer cover.
Replacing a hard disk drive
Note:
For this procedure, it helps to lay the computer flat.
To replace a hard disk drive:
Step 1.
Remove the computer cover. Refer to “Removing the computer cover”.
Step 2.
Disconnect the data and power cables from the hard disk drive.
Step 3.
Lift up the plastic handle and slide the hard disk drive out of the drive bay.
1
2
Chapter 8
.
Replacing hardware
27