Lenovo M55p Hardware Maintenance Manual - Page 79
POST Error Code, FRU/Action, Asset ID, System Security: Asset ID Antenna has been installed
UPC - 883609117436
View all Lenovo M55p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
POST Error Code FRU/Action 179 Boot Integrity Services Segment Error 1. Perform a flash update to update the BIOS level 2. System board 184 Asset Control Antenna not detected 1. Make sure Asset Care and ™Asset ID are enabled in Setup 2. RFID Antenna 3. Replace system board 186 Security Hardware Control Logic Error If problem persists, replace the system board 190 System Security: Invalid Remote Change Requested If problem persists, replace the system board 191 System Security: Embedded Security hardware Reset If problem persists, replace the system board 192 System Security: Embedded Security hardware tamper detected If problem persists, replace the system board 193 System Security: Embedded Security hardware Removed If problem persists, replace the system board 194 System Security: Asset ID Antenna has been Removed If problem persists, replace the system board 195 System Security: Asset ID Antenna has been installed If problem persists, replace the system board 196 System Tampered Cleared If problem persists, replace the system board 201 Memory error 1. Run Enhanced Diagnostics Memory Test 2. Memory module 3. System board 210 Keyboard stuck key error 1. Check for stuck keys 2. Replace the keyboard 211 Keyboard error 1. Make sure keyboard is connected correctly 2. Check for stuck keys 3. Replace the keyboard 212 Keyboard controller error 1. Replace the keyboard 2. If problem persists, replace the system board 250 Battery is dead 1. Replace the battery and run Setup 2. If problem persists, replace the system board 270 Real time clock error 1. Run Setup and set date and time 2. If problem persists, replace the system board 271 Date and time out of range 1. Run Setup and set date and time 2. If problem persists, replace the system board 662 Configuration Change has occurred Diskette drive configuration error or wrong diskette drive type; run Setup. 1762 Configuration Change has occurred 1. Run Setup and verify hard disk drive settings. 2. Run hard disk drive diagnostics. 3. Replace hard disk drive 1800 PCI/PnP Error! No Hardware Interrupt Available 1. Run Setup and verify PCI/ISA configuration settings. 2. Run diagnostics. 3. Replace PCI Adapter Chapter 7. Symptom-to-FRU Index 73