Lenovo Miix 3-830 Hardware Maintenance Manual - Lenovo MIIX 3-830 - Page 43

System board, Important notices for handling the system board

Get Lenovo Miix 3-830 PDF manuals and user guides View all Lenovo Miix 3-830 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 43 highlights

Lenovo MIIX 3-830 1050 System board Important notices for handling the system board: When handling the system board, bear the following in mind. • Be careful not to drop the system board on a bench top that has a hard surface, such as metal, wood, or composite. • Avoid rough handling of any kind. • In the whole process, make sure not to drop or stack the system board. • If you put a system board down, make sure to put it only on a padded surface such as an ESD mat or conductive corrugated material. For access, remove these FRUs in order: • "1010 LCD cover" on page 30 • "1020 Battery pack" on page 33 • "1030 Speaker" on page 36 • "1040 Camera" on page 38 Figure 5. Removal steps of system board Remove the two pieces of conductive tape. Unplug the three connectors shown by arrows 1, 2 and 3. Release the microphone module from the microphone hole 4. 2 3 1 2 3 4 When installing: Make sure that all the connectors are attached firmly. 39

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
39
Lenovo MIIX 3-830
1050
System board
Important notices for handling the system board:
When handling the system board, bear the following in mind.
• Be careful not to drop the system board on a bench top that has a hard surface,
such as metal, wood, or composite.
• Avoid rough handling of any kind.
•
In the whole process, make sure not to drop or stack the system board.
•
If you put a system board down, make sure to put it only on a padded surface such
as an ESD mat or conductive corrugated material.
For access, remove these FRUs in order:
•
“1010 LCD cover” on page 30
•
“1020 Battery pack” on page 33
•
“1030 Speaker” on page 36
•
“1040 Camera” on page 38
Figure 5. Removal steps of system board
Remove the two pieces of conductive tape. Unplug the three connectors
shown by arrows
1
,
2
and
3
. Release the microphone module from the
microphone hole
4
.
4
2
3
2
3
1
When installing:
Make sure that all the connectors are attached firmly.