Lenovo Storage E1012 (English) Setup Guide - Lenovo Storage S3200, S2200 - Page 21
Installing the enclosures, Installation checklist, FDE considerations
View all Lenovo Storage E1012 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
2 Installing the enclosures Installation checklist The following table outlines the steps required to install the enclosures, and initially configure and provision the storage system. To ensure successful installation, perform the tasks in the order presented. Table 3 Installation checklist Step Task Where to find procedure 1. Install the controller enclosure and optional See the rack-mount bracket kit installation instructions drive enclosures in the rack, and attach the enclosure bezel.1 pertaining to your enclosure. Also refer to the bezel attachment instructions for your enclosure 2. Connect controller enclosure and optional drive enclosures. See Connecting the controller enclosure and drive enclosures on page 22. 3. Connect power cords. See Powering on/powering off on page 28. 4. Test enclosure connectivity. See Testing enclosure connections on page 28. 5. Install required host software. See Host system requirements on page 30. 6. Connect hosts.2 See Connecting the enclosure to hosts on page 30. 7. Connect remote management hosts.2 See Connecting a management host on the network, page 40. 8. Obtain IP values and set network port IP properties on the controller enclosure. See Obtaining IP values on page 41. For USB CLI port and cable use, see Appendix D. 9. Use the CLI to set the host interface protocol. See CNC technology on page 30. The CNC models allow you to set the host interface protocol for your qualified SFP option. Use the set host-port-mode command as described in the CLI Reference Guide or online help. 10. Perform initial configuration tasks3: Topics below correspond to bullets at left: • Sign-in to the web-browser interface to access the application GUI. See "Getting Started" in the web-posted Lenovo Storage Manager Guide. • Verify firmware revisions and update if necessary. See Updating firmware. Also see the same topic in the Storage Manager Guide. • Initially configure and provision the system See "Configuring the System" and "Provisioning the System" using the Storage Management Console. topics in the Storage Manager Guide or online help. 1See the Lenovo Storage CRU Installation and Replacement Guide for illustrations and narrative describing attachment of enclosure bezels to 2U24 and 2U12 chassis. See also Enclosure bezel attachment and removal on page 56. 2For more about hosts, see the "About hosts" topic in the Storage Manager Guide. 3The Storage Management Console is introduced in Accessing the SMC on page 45. See the Storage Manager Guide or online help for additional information. NOTE: Additional installation notes: • Controller modules within the same enclosure must be of the same type. • For optimal performance, do not mix 6 Gb and 3 Gb disk drives within the same enclosure. FDE considerations The Full Disk Encryption feature available via the management interfaces requires use of self-encrypting drives (SED) which are also referred to as FDE-capable disk drive modules. When installing FDE-capable disk drive modules, follow the same procedures for installing disks that do not support FDE. The exception occurs when you move FDE-capable disk drive modules for one or more disk groups to a different system, which requires additional steps. Lenovo Storage S3200/S2200 Setup Guide 21