Lenovo Storage E1024 (English) Setup Guide - Lenovo Storage S3200, S2200 - Page 42
Table 5, Start and con a terminal emulator, such as HyperTerminal or VT-100
View all Lenovo Storage E1024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Connect USB cable to CLI port on controller face plate Host Not ISnhteorwfance CLI SERVICE−2 CLI ACT LINK SERVICE−1 6Gb/s CACHE DIRTY LINK Figure 30 Connecting a USB cable to the CLI port 3. Enable the CLI port for subsequent communication: • Linux customers should enter the command syntax provided in Setting parameters for the device driver on page 79. • Windows customers should locate the downloaded device driver described in Obtaining the software download on page 78, and follow the instructions provided for proper installation. 4. Start and configure a terminal emulator, such as HyperTerminal or VT-100, using the display settings in Table 5 and the connection settings in Table 6 (also, see the note following this procedure). Table 5 Terminal emulator display settings Parameter Terminal emulation mode Font Translations Columns Value VT-100 or ANSI (for color support) Terminal None 80 Table 6 Terminal emulator connection settings Parameter Connector Baud rate Data bits Parity Stop bits Flow control Value COM3 (for example)1,2 115,200 8 None 1 None 1Your server or laptop configuration determines which COM port is used for Disk Array USB Port. 2Verify the appropriate COM port for use with the CLI. 5. In the terminal emulator, connect to controller A. 6. Press Enter to display the CLI prompt (#). The CLI displays the system version, MC version, and login prompt: a. At the login prompt, enter the default user manage. b. Enter the default password !manage. If the default user or password-or both-have been changed for security reasons, enter the secure login credentials instead of the defaults shown above. 42 Connecting hosts