Lenovo ThinkPad 365E-ED ThinkPad 365, SelectaDock I - Hardware Maintenance Man - Page 67

Viewing the Test Groups As you move the cursor bar up or down in the Module Tests menu, the right hand screen changes to show the attributes, parameters, and the selected tests of the corresponding Test Group. The "DIAMOND" mark indicates a module selected for testing. Module Testing Mode If the Quick Check does not find a problem, or you want to perform in-depth testing, the Module Testing mode provides a method to run individual tests on a single module. For example, you can run an individual test for the diskette drive, or you can the test for all selected modules. To start the Module Tests: Attention To use the IBM ThinkPad 365 Advanced Diagnostics Diskette, you must have at least 500KB of free memory. Be sure to read the "README.PO" file on the IBM ThinkPad 365 Advanced Diagnostics Diskette before using the following instructions. 1. Power-off the computer. 2. Insert the IBM ThinkPad 365 Advanced Diagnostics Diskette into drive A. 3. Power-on the computer. 4. Follow the instructions on the screen and proceed to the Main Menu. Allow two to four minutes for the diagnostic programs to load. 5. At the Main Menu, select Diagnostics. 6. At the Diagnostics Menu, select Module Tests. 7. At the Module Tests Menu, select the modules to test. 8. Use the up and down arrow keys (↑ and ↓) to move the highlight bar from one selection to the next. 9. Press Enter to run the tests. 10. Do not press any key until prompted, then follow the instructions on the screen. 11. Follow the instructions on the screen. 12. Select Exit. Running Selected Module Tests To run a selected tests for a test group: 1. Use the up and down arrow keys (↑ and ↓) to move the cursor to your selection. 2. Press Enter. Note: A "DIAMOND" appears next to your selection. ThinkPad 365 (2625) 55