Lenovo ThinkPad Edge E220s (English) User Guide - Page 119
Installing Windows XP
View all Lenovo ThinkPad Edge E220s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
The name of each subfolder is the number of a fix module. For information about each fix module, visit the Microsoft Knowledge Base homepage at: http://support.microsoft.com/, type the number of the fix module you need in the search field, and click Search. Note: The Web site address might change without notice. If the homepage is not displayed, search for it from the Microsoft top page. To install a fix module, run the EXE file in a subfolder and follow the instructions on the screen. Note: If you remove the hard disk drive from the computer with a single-core processor and install it on a computer with a dual-core processor, you can get access to the hard disk drive. The opposite, however, is not true: If you remove the hard disk drive from a computer with a dual-core processor and install it on a computer with a single-core processor, you cannot get access to the hard disk drive. Installing Windows XP Before you start, print these instructions. Note: Your computer supports Windows XP with Service Pack 3. Before you install the Windows XP Service Pack 3, make sure you install the Windows XP Service Pack 2 first. Note: You can attach a USB CD or DVD drive to the USB connector. You must install Intel Rapid Storage Technology Driver before installing the operating system. To install it, you may need to attach a diskette drive to your computer. If you have a diskette drive, follow the procedure below. Before installing the operating system, install Intel Rapid Storage Technology Driver as follows: Note: Be sure to install Intel Rapid Storage Technology Driver before installing the operating system. Otherwise your computer will not respond; it will only display a blue screen. 1. Attach a diskette drive to your computer. 2. Copy Intel Rapid Storage Technology Driver from C:\SWTOOLS\DRIVERS\IMSM to a diskette. 3. To make sure that SATA AHCI is enabled, start the ThinkPad Setup. 4. Select Config. 5. Select Serial ATA (SATA). 6. Select AHCI . 7. Change the startup sequence of your computer. Select Startup. 8. Select UEFI/Legacy Boot. 9. Select Both or Legacy Only. 10. Press F10. 11. Insert the CD for Windows XP integrated with Service Pack 2 into the CD or DVD drive, and restart the computer. 12. To install a third-party SCSI driver first, press F6. 13. When prompted, select S for Specify Additional Device. 14. When prompted, insert the diskette that you created in step 2, and press Enter. 15. Scroll the list of drivers. If the SATA setting of you computer is set to AHCI, select Intel® Mobile Express Chipset SATA AHCI Controller. 16. To continue the installation, press Enter again. Leave the diskette in the drive until the next reboot; the software may need to be copied from the diskette again when the files are copied during setup. 17. Complete the installation of Windows XP Service Pack 2 by following OS installing instructions. Chapter 8. Advanced configuration 101