Lenovo ThinkPad R30 ThinkPad R30, R31 - Hardware Maintenance Manual (September - Page 36

Note: These events depend on the Power button, Sleep button and Lid settings (options set to hibernate mode) in the ″Advanced″ page of the ″Power Management Properties″ screen. v Hibernation requested by the Sleep button (Fn+F4) or (Fn+F12) v Hibernation requested by the power button v Hibernation requested by closing the lid. Events that cause the computer to exit hibernation mode: v RTC alarm v Power-on switch is operated v WOL (wake on Lan) When power is turned on, the hibernation history in the boot record on the hard disk is recognized and the system status is restored from the hard disk to resume operation. Fn key combinations The following table shows the Fn key and function key combinations and their corresponding functions. Some of the keys do not work if proper device drivers and utilities are not installed. Fn key Fn+F3 Fn+F4 Fn+F7 Fn+F8 Fn+F12 Fn+PageUp Fn+Home Fn+End Function Display off Sleep button Switch display output location. Display expansion Hibernation Thinkpad light Brightness up Brightness down Product recovery program Restoring the Pre-installed Software To restore the pre-installed software, you can use either the Product Recovery program or a Recovery CD. The Product Recovery program is in a section of the hard disk drive (the Service Partition) that is not displayed by Windows Explorer. Use the Recovery CD if it was provided with the computer. Note: The recovery process might take up to 2 hours. To use the Product Recovery program to restore the pre-installed software, do the following: 30 ThinkPad R30/R31 HMM