Lenovo ThinkServer RD330 (English) Rack Installation Instructions - Page 2

The dimensions of the rack cabinet must meet the following requirements: Figure 1. The dimension requirements of the rack cabinet 1 Rear mounting flange 2 Front mounting flange 3 Front door of the rack cabinet The following table explains the dimension requirements of the rack cabinet. Table 1. The dimension requirements of the rack cabinet Item Dimensions Description A 750 mm - 900 mm （29.53 - Item A refers to the distance between the front mounting flange 2 and the 35.43 inches） rear mounting flange 1 . The distance should be 750 mm (29.53 inches) in minimum and 900 mm ( 35.43 inches) in maximum. B > 474 mm (18.66 inches) Item B refers to the width of the server including the rail kit when the server is installed into the rack cabinet. The width should exceed 474 mm (18.66 inches). D > 60 mm (2.36 inches) Item D refers to the distance between the front mounting flange 2 and the inside of the front door of the rack cabinet 3 . The distance should exceed 60 mm (2.36 inches). This clearance is required for the chassis pull handles on the front of the server as well as air circulation through the cabinet. L > 950 mm (37.4 inches) Item L refers to the distance between the front mounting flange 2 and the rear of the server. The distance should exceed 950 mm (37.4 inches). This clearance is used to save adequate space for the cable management arm. Before you install the server into a rack cabinet, review the following guidelines to help you in your installation and avoid the risk of personal injury and or damage to your product: • Two or more people are required to lift a server, move a server, or install a server into a rack cabinet if the server meets one of the following criteria: 2