LevelOne ADE-8208 Manual - Page 9
Connect ADE-8002 to DVI Monitor by DVI Cable
View all LevelOne ADE-8208 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
(4) Install ADE-8002: A. Plug power adaptor to ADE-8002, the orange LED above RJ-45 should be ON to indicate the power on status. The other LED should turn off, since there is no input of video signal from "LINK IN" port. B. The "Auto" led in the front panel will turn ON as the EQ/FOCUS control switch to the left end and the EQ/FOCUS will stay on AUTO, this will not function until the receiver received video signal from "LINK IN" port. C. Connect DVI monitor's DVI cable to the receiver. Connect ADE-8002 to DVI Monitor by DVI Cable (5) Selection of Cat5/5e/6 cable: You may use most of current Cat5/5e/6 cables, and since the quality varies, we do encounter some cables not perform well, even it is expensive. Therefore, please test your current cables before you install the devices on the site. For some environment need to prevent potential interference, the FTP type cable is recommended. The connector must be made by 568B-568B type. The EIA/TIA definition of 568B in the pin assignment is (1)orange white, (2)orange, (3)green white, (4)blue, (5)blue white, (6)green, (7)brown white, and (8)brown.