LevelOne FVM-1101 Manual - Page 4

Preparation before Installing and Connection

Get LevelOne FVM-1101 PDF manuals and user guides View all LevelOne FVM-1101 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

Chapter 3 Preparation before Installing and Connection 3.1 Optical port connection FVM-1101 / FVM-1220 / FVM-1000 supports hot plug SFP port. When one pair of optical modules is connected, four requirements need to be fulfilled. 1. Optical wavelengths must be the same, especially for single fiber optical ports, require transmit-receive optical wave with difference frequencies. The transmitting and receiving operating wavelengths should match each other (for example: if TX is 1310nm, and the opposite end RX should be 1310nm). 2. The rate of optical modules must be the same. 3. The optical powers must be matching 4. Comply with the Ethernet protocol of IEEE802.3、IEEE802.3u、IEEE802.3z、IEEE802.3x. 3.2 Network-building method When connecting products in Network, Rules of 3.1 must be obeyed rules for connecting optical ports: for FVM-1101 / FVM-1220 / FVM-1000 fiber media converters. please build network according to the following sketch maps. (1) (2) 3.3 Test Test the optical port connection between the device and Media Converter. After the OAM Discovery of Media Converter, test RFC-2544 and MIB variable quantity response. 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
4
Chapter 3 Preparation before Installing and Connection
3.1 Optical port connection
FVM-1101 / FVM-1220 / FVM-1000 supports hot plug SFP port. When one pair of optical modules is
connected, four requirements need to be fulfilled.
1.
Optical wavelengths must be the same, especially for single fiber optical ports, require
transmit-receive optical wave with difference frequencies.
The transmitting and receiving
operating wavelengths should match each other (for example: if TX is 1310nm, and the
opposite end RX should be 1310nm).
2.
The rate of optical modules must be the same.
3.
The optical powers must be matching
4.
Comply with the Ethernet protocol of IEEE802.3
、
IEEE802.3u
、
IEEE802.3z
、
IEEE802.3x.
3.2 Network-building method
When connecting products in Network, Rules of 3.1 must be obeyed rules for connecting optical ports:
for FVM-1101 / FVM-1220 / FVM-1000 fiber media converters. please build network according to the
following sketch maps.
3.3 Test
Test the optical port connection between the device and Media Converter. After the OAM Discovery of
Media Converter, test RFC-2544 and MIB variable quantity response.
(1)
(2)