LevelOne FVT-0104TXFC Datasheet - Page 1

ProCon_FVT-0103TXFC/ 0104TXFC one world_one brand_one level_ 100TX to 100FX-SC POE Converter LevelOne's FVT-0103TXFC and FVT-0104TXFC are new Power-overEthernet-converters that transfer data from 10/100BaseTX copper to fiber interfaces. These POE Converters are designed to receive data and power from POE networks and then to refer data out through fiber connections thus eliminating extra power cables to extend the usefulness of the network LevelOne's POE converter complies with IEEE802.3af standard. The 10/100 Base-TX port auto-senses 10 or 100Mbps connection speeds, auto-negotiates half-/full-duplex modes, and auto-selects MDI-X media type. It comes in two models: FVT-0103TXFC with Multi-mode SC connector and FVT-0104TXFC with Single-mode SC connector. These converters will give your POE network the ability to interface with fiber connections over a distance of up to 20km. With its compact design, our POE converters easily fit on any limited space. No software is required. You can easily active this device by simply connecting it to the network cable and it's ready to go. FVT-0103TXFC FVT-0104TXFC Related Products FVT-0203TXFC 100TX to 100FX-SC MM Converter w/POE Injector FVT-0204TXFC 100TX to 100FX-SC SM Converter w/POE Injector Key Features Technical Specification 10/100Base-TX UTP to 100Base-FX fiber media conversion Complies with IEEE 802.3af POE standard Over-currant protection and Under-currant detection Choice of SC connectors for multi- and singlemode DIP Switch to set configurations Product Diagram Ordering Information Standards Compliance IEEE 802.3/ IEEE 802.3u IEEE 802.3af Power Over Ethernet Connector 10/100Base-TX: STP RJ-45 100Base-FX: MM SC, SM SC Fiber Cable 50/125, 62.5/125 or 100/140m multi-mode 8.3/125, 8.7/125, 9/125 or 10/125m single-mode Data Transfer Rate 100Mbps: 148,800 pps 10Mpbs: 14,880 pps Flow control IEEE802.3x for full-duplex Backpressure flow control for half-duplex POE Power Reception Supports "Ethernet" via TP pin 1,2,3,6 "Mid Span": via TP pin 4,5,7,8 LED Indicators Power, PoE, TP Link/Act, 100, FX Link/Act, FDX/COL Power Requirement 60mA@-48VDC from IEEE802.3af PSE or PoE injector Temperature Operating: 0°C ~50°C Humidity 5%~90% (RH) Dimension 26.2(H) x 70.3(W) x 94(D) mm Certification FCC, CE FVT-0103TXFC: 100TX to 100FX-SC Multi-Mode POE Converter FVT-0104TXFC: 100TX to 100FX-SC Single-Mode POE Converter (20km) For more information, please contact your LevelOne representative, or visit www.level1.com All technical specifications are subject to change without notice. All mentioned brand names are registered trademarks and property of their owners