LevelOne IES-0881 Quick Install Guide - Page 2
Power Input, Console Configuration, Web Configuration
View all LevelOne IES-0881 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Terminal Block Power Input Power + 47 - 57VDC - Power Ground Earth Ground Console Configuration 1. Connect to the switch console: 2. Connect the DB9 straight cable to the RS-232 serial port of the device and the RS-232 serial port of the terminal or computer running the terminal emulation application. Direct access to the administration console is achieved by directly connecting a terminal or a PC equipped with a terminal-emulation program (such as HyperTerminal) to the switch console port. 3. Configuration settings of the terminal-emulation program: 4. Baud rate: 115,200bps, Data bits: 8, Parity: none, Stop bit: 1, Flow control: none. 5. Press the "Enter" key. The Command Line Interface (CLI) screen should appear as below: 6. Logon to Exec Mode (View Mode): 7. At the "switch_a login:" prompt just type in "root" and press to logon to Exec Mode (or View Mode). And the "switch_a>" prompt will show on the screen. IES-0881 Page 4 Terminal Mode). And the "switch_a(config)#" prompt will show on the screen. 12. Set new IP address and subnet mask for Switch: 13. At the "switch_a(config)#" prompt just type in "interface vlan1.1" and press to logon to vlan 1 (vlan1.1 means vlan 1). And the "switch_a(config-if)#" prompt will show on the screen. 14. Command Syntax: "ip address A.B.C.D/M". "A.B.C.D" specifies IP address. "M" specifies IP subnet mask. "M"= 8: 255.0.0.0, 16:255.255.0.0, or 24: 255.255.255.0. 15. For example, At the "switch_a(config-if)#" prompt just type in "ip address 192.168.1.10/24" and press to set new IP address (192.168.1.10) and new IP subnet mask (255.255.255.0) for Switch 8. Logon to Privileged Exec Mode (Enable Mode): 9. At the "switch_a>" prompt just type in "enable" and press to logon to Privileged Exec Mode (or Enable Mode). And the "switch_a#" prompt will show on the screen. 10. Logon to Configure Mode (Configure Terminal Mode): 11. At the "switch_a#" prompt just type in "configure terminal" and press to logon to Configure Mode (or Configure IES-0881 Page 5 Web Configuration 1. Login the switch: 2. Specify the default IP address (192.168.1.10) of the switch in the web browser. A login window will be shown as below: 3. Enter the factory default login ID: root. 4. Enter the factory default password (no password). 5. Then click on the "Login" button to log on to the switch. IES-0881 Page 6 Note: Please refer to User Manual for more detailed information IES-0881 Page 7