LevelOne PLI-3021 PLI-3021D Manual - Page 19

Device Name, MAC Address, Password, Set Device Password

Get LevelOne PLI-3021 | PLI-3021D PDF manuals and user guides View all LevelOne PLI-3021 | PLI-3021D manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

above the Remote devices panel showing whether the Autoscan functionality is turned ON or OFF. The following information is displayed for all devices that appear in the lower panel. Device Name column shows the default device name, which may be user re-defined. A user can change the name by either using the rename button or by clicking on the name and editing in-place. An icon is usually shown with the name. By default, the icon is always accompanied by a device name. MAC Address column shows the Remote device's MAC address. Password column by default is blank and 'Enter Password' button can be used to enter it. To set the Password of the device (required when creating a private network), first select the device by clicking on its name in the lower panel and then click on the Enter Password button. A dialog box will appear as shown in Figure 3-3 to type the password. The selected device name is shown above the password field and the password can be verified by hitting the OK button. The Password field accepts the Device password in any case formats, with or without dashed between them. If a device was not found, the user will be notified along with the suggestions to resolve common problems. This process might take a few seconds to get completed. Figure 3-3: Set Device Password 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
17
above the Remote devices panel showing whether the Autoscan functionality is turned ON or
OFF. The following information is displayed for all devices that appear in the lower panel.
Device Name
column shows the default device name, which may be user re-defined. A user can
change the name by either using the rename button or by clicking on the name and editing
in-place. An icon is usually shown with the name. By default, the icon is always accompanied by
a device name.
MAC Address
column shows the Remote device’s MAC address.
Password
column by default is blank and ‘Enter Password’ button can be used to enter it.
To set the
Password
of the device (required when creating a private network), first select the
device by clicking on its name in the lower panel and then click on the Enter Password button. A
dialog box will appear as shown in Figure 3-3 to type the password. The selected device name is
shown above the password field and the password can be verified by hitting the OK button. The
Password field accepts the Device password in any case formats, with or without dashed
between them. If a device was not found, the user will be notified along with the suggestions to
resolve common problems. This process might take a few seconds to get completed.
Figure 3-3: Set Device Password