LevelOne PLI-4051 Quick Install Guide - Page 5

English Hardware Installation Ethernet Cable (RJ-45) Powerline Room 1 Notebook PC Room 2 Internet ADSL / Cable Modem Front Panel LEDs On Normal Operation The Powerline network is active. This means that at least one other HomePlug Device was detected. Ethernet connection is active Flash NA Off No Power - Data is being transmitted or received via the Powerline network. Data is being transmitted or received via the Ethernet Port. Powerline network is not available - no other HomePlug devices were detected. No Ethernet connection Configuration requires the use of Windows PC. Once configured, any device may be connected to the 500Mbps HomePlug AV Adapter's Ethernet port. To perform configuration, follow the procedures list below. 1. Connect a RJ-45 Ethernet cable from the 500Mbps HomePlug AV Adapter's Ethernet port to your PC. 2. Connect a RJ-45 Ethernet cable from your xDSL/Cable Modem's Ethernet port to the other Powerline Ethernet Adapter's LAN Ports. 3. Plug the500Mbps HomePlug AV Adapter into a power outlet. 4. Wait a few seconds for start-up to be completed, and then check the LEDs.  The  The  The LED should be ON. LED will be ON if other HomePlug devices are detected, otherwise it will be OFF. LED should be ON - 4 -