LevelOne PLI-4052D Quick Install Guide - Page 5
English - 500mbps
View all LevelOne PLI-4052D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
English Hardware Installation Ethernet Cable (RJ-45) Powerline Room 1 Notebook PC Room 2 Internet ADSL / Cable Modem Front Panel LEDs On PWR Normal Operation The Powerline network is active. PL This means that at least one other HomePlug Device was detected. ETH Ethernet connection is active Flash NA - Data is being transmitted or received via the Powerline network. Data is being transmitted or received via the Ethernet Port. Off No Power Powerline network is not available - no other HomePlug devices were detected. No Ethernet connection Configuration requires the use of Windows PC. Once configured, any device may be connected to the 500Mbps HomePlug AV Adapter's Ethernet port. To perform configuration, follow the procedures list below. 1. Connect a RJ-45 Ethernet cable from the 500Mbps HomePlug AV Adapter's Ethernet port to your PC. 2. Connect a RJ-45 Ethernet cable from your xDSL/Cable Modem's Ethernet port to the other Powerline Ethernet Adapter's LAN Ports. 3. Plug the500Mbps HomePlug AV Adapter into a power outlet. 4. Wait a few seconds for start-up to be completed, and then check the LEDs. The PWR LED should be ON. The PL LED will be ON if other HomePlug devices are detected, otherwise it will be OFF. The ETH LED should be ON - 4 -