LevelOne WUA-0624 Manual - Page 30

station screen.

Get LevelOne WUA-0624 PDF manuals and user guides View all LevelOne WUA-0624 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Q3: Failed to enable ICS. A3: Microsoft ICS service can only combine one group of WAN and LAN. This message indicates ICS may have been enabled by other network adapters. 1.Please manually cancel or restart and cancel ICS, then re-switch to AP mode. 2. This dialogue box appears because virtual wi-fi miniport adapter can only be used by one wireless network adapter at a time. Please disable any other non-LevelOne wireless network adapters and re-switch to AP mode. Q4: Under Windows 7,when I switch from station mode to AP mode ,the screen flashes"Disabling ICS， please wait......"and immediately return to station screen. A4: This is because you have disabled "Microsoft Virtual WiFi Miniport Adapter",please re-enable it and then switch to AP mode. Q5:Client cannot obtain IP when connected to soft AP of the wireless network adapter. A5:Manually set an IP address at the same net segment as that of the AP and the gateway and DNS at the IP address of AP. Thus, communication can be achieved. Q6: The SSID is not fully displayed on the wireless network list, what should I do? A6: Keep the mouse on the displayed SSID for about 2 seconds, as the below picture shows,and you'll see the full SSID on the appearing box. -28-

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
-28-
Q3
: Failed to enable ICS.
A3
: Microsoft ICS service can only combine one group of WAN and LAN. This
message indicates ICS may have been enabled by other network adapters.
1.Please manually cancel or restart and cancel ICS, then re-switch to AP
mode.
2. This dialogue box appears because virtual wi-fi miniport adapter can only
be used by one wireless network adapter at a time. Please disable any other
non-LevelOne wireless network adapters and re-switch to AP mode.
Q4
: Under Windows 7,when I switch from station mode to AP mode ,the
screen flashes“Disabling ICS
，
please wait……”and immediately return to
station screen.
A4
: This is because you have disabled “Microsoft Virtual WiFi Miniport
Adapter”,please re
-enable it and then switch to AP mode.
Q5
:Client cannot obtain IP when connected to soft AP of the wireless
network adapter.
A5
:Manually set an IP address at the same net segment as that of the AP and
the gateway and DNS at the IP address of AP. Thus, communication can be
achieved.
Q6:
The SSID is not fully displayed on the wireless network list, what should I
do?
A6:
Keep the mouse on the displayed SSID for about 2 seconds, as the below
picture shows,and you’ll see the full SSID on the appearing box.