Lexmark 920dtn Menus and Messages - Page 45
Emul Error Load Emul Option, Transfer Belt Life Warning
UPC - 734646020848
View all Lexmark 920dtn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Message Restoring Factory Defaults Restoring held job(s) x/y Serial Some held jobs were lost Staples Empty Staples Low Standard Bin Full Submitting selection Transfer Belt Life Warning Tray Empty Tray Low Tray Missing Tray Too Full USB USB USB drive removed View supplies Waiting 1565 Emul Error Load Emul Option 30 Coating roll missing 30 print unit missing 32 Replace unsupported cartridge Action Wait for the message to clear. Note: When factory default settings are restored: • All downloaded resources (fonts, macros, symbol sets) in the printer memory are deleted. • All menu settings return to the factory default setting except: - The Display Language setting in the "Setup" Menu. - All settings in the "Parallel" Menu, "Serial" Menu, "Network" Menu, "Infrared" Menu, "LocalTalk" Menu, "USB" Menu, and "Fax" Menu. • Wait for the message to clear. • Select Quit restoring to delete unrestored Print and Hold jobs. Note: x represents the number of the job being restored, and y represents the total number of jobs to be restored. A serial interface is the active communication link. • Select Continue to clear the message and continue printing. The printer frees memory by deleting the oldest held job and continues deleting held jobs until there is enough printer memory to process the job. • Cancel the current job. • Install a new staple cartridge. • Select Continue to clear the message and continue printing without stapling. • Cancel the current job. Remove the stack of paper from the bin to clear the message. Wait for the message to clear. • Select Continue to clear the message and print without installing a new transfer belt. • Replace the transfer belt and, if necessary, reset the printer internal counter for the transfer belt. Load paper in the tray to clear the message. Add paper to the tray to clear the message. Insert the tray into the printer. Open the specified tray, and remove some of the media. The printer is processing data through the specified USB port. • Wait for the message to clear. • Insert the USB drive. Displays the current level of all printer supplies. The printer has received a page of data to print, but is waiting for an End of Job command, a Form Feed command, or additional data. • Press Select to print the contents of the buffer. • Cancel the current job. The printer automatically clears the message in 30 seconds, and then disables the download emulator on the firmware card. Download the correct download emulator version from the Lexmark Web site. Install the coating roll, and close the top cover. Install the specified print unit, and close the top cover. Remove the toner cartridge, and install a supported one. Understanding printer messages 45