Lexmark C500n Menus and Messages - Page 12
Warning Messages, Service Messages, Network Menu, Utility Menu, Calibration - replace cg belt
View all Lexmark C500n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Understanding printer messages Warning Messages During warning messages, the error light is off. Message Calibrating Check Output Tray Check Toner xxxx Duplicate IPaddr Replace Belt CG Replace Fuser Replace Parts xxx Replace WT. Pack TMA Sensor Error Warming Up Action The printer is calibrating. Output tray is nearly full. Remove all printed media from the output tray. The toner of color "x"-K (black), Y (yellow), M (magenta), or C (cyan), may be up to four toners KYMC-will soon be exhausted. The remaining toner can print only 20 to 500 images, depending on the coverage of the toner color. You can print approximately 100-125 pages after one of the messages comes on. The IP address has been duplicated. Disconnect the LAN cable, change the IP address, and reconnect the LAN. For instructions on setting the IP address, see the Network Menu. Replace the photodeveloper belt. For instructions on resetting the photodeveloper belt count, see the Utility Menu. Replace the fuser unit. For instructions on resetting the fuser count, see the Utility Menu. Periodic maintenance is required. This does not include replacing the fuser unit. The waste toner bottle is nearly full and will need to be replaced. The printer will be able to print approximately 50 more pages and then will no longer print until the waste toner bottle is replaced. A calibrating error has been detected. To clear the message, turn the printer off, reinstall the paper tray, and turn the printer on. If the error message continues, call for service. Note: This error only occurs when calibration mode is ON. For information on how to turn calibration on or off, see Calibration. If calibration is turned to OFF, print quality may be affected. Wait for the message to clear. Service Messages During service messages, the error light is on and the printer requires immediate assistance. Check Front Cover Close Back Cover Close Front Cover Close Top Cover Data Error The front cover is not firmly closed. Open the front cover and close it until it locks. Close the specified door to clear the message. Invalid print data has been detected. To clear the message: 1 Press to take the printer offline. 2 Press and hold for at least 3 seconds to clear all data. 3 Press to bring the printer back online. 12