Lexmark C520 User's Guide - Page 12
Installing drivers for local printing, Setting parameters in the printer, Reports, Menu Settings
View all Lexmark C520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installing drivers for local printing Before printing, establishing communication between the printer and computer is required. To do this: 1 Set serial parameters in the printer. 2 Install a printer driver on the attached computer. 3 Match the serial settings in the COM port. Setting parameters in the printer 1 Press on the operator panel. 2 Press until Reports appears, and then press . Note: For information about serial menus and messages, see the publications CD that shipped with the printer. 3 Press until Menu Settings Page appears, and then press . The printer returns to Ready. 4 Press . 5 Press until Network/Ports appears, and then press . 6 Press port.) until Serial or Serial [x] appears, and then press . ([x] is the number of the serial 7 Press until appears, and then press a change). (where is the parameter required for 8 Press until appears, and then press change). (where is the setting required for a Note the following restrictions: • Maximum baud rate supported is 115,200. • Data Bits must be set to 7 or 8. • Parity must be set to Even, Odd, or None. • Stop Bits must be set to 2. • Flow Control recommended protocol setting is Xon/Xoff. 9 Press to select the setting. The printer returns to Serial or Serial [x]. 10 Print a Menu Settings page, and verify that the serial parameters are correct. Note: Keep this page for later use. a Press on the operator panel. b Press until Reports appears, and then press . c Press until Menu Settings Page appears, and then press . d Look under the Standard Serial (or Serial Option X if a serial interface card is installed) heading to find the serial parameters. Windows 12