Lexmark C780 Service Manual - Page 79
xx paper jam service check, compensa, tor pick, assembly, removal on, HCIT
View all Lexmark C780 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
5061 Step 7 Actions and questions Make sure the pass thru sensor is correctly connected to the Tray x system board. Is the sensor cable connected correctly? 8 Check the autocompensator cable for correct installation to Tray x system board. Is the cable connected correctly? Yes Replace the FRUs in the following order: 1. Pass thru sensor assembly. 2. Electronics/ size sensing assembly with system board. Replace the option, or replace the following parts in the order until the error is cleared: • Autocompensator pick assembly. See "Autocompensator pick assembly removal" on page 4-27. • Tray x system board. No Install the cable correctly. Install the cable correctly. 242.xx paper jam service check For second installed tray/option. 500-sheet drawer option Media does not reach the pass thru sensor. Step 1 Actions and questions Is Tray 2 a HCIT 2000-sheet option? 2 Make sure the media installed in the tray meets specifications. Does the media meet specifications? 3 Make sure the media is loaded correctly. Make sure the side and back restraints are located and seated properly. Is the media loaded correctly? Yes Go to "HCIT" on page 2-39 Go to step 3 Go to step 4 No Go to step 2 Inform the customer that media loaded in Tray x does not meet media specifications. Load the media correctly. Diagnostic information 2-37