Lexmark E260dn Service Manual - Page 94
Diagnostics mode selections - lights flashing
View all Lexmark E260dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
4513-220, -230 Diagnostics mode selections To enter the Diagnostics mode: 1. Turn off the printer. 2. Open the front access door. 3. Turn on the printer while pressing and holding Cancel . 4. Close the front access door once the Error light displays. Print the menu page by pressing and holding Continue until all of the lights flash. Follow the instructions on the menu page to access the menu items shown in the table below. Menu item Use setting to Value Prt Quality Pgs Print test pages by pressing and holding until the lights flash. Help isolate print quality problems, such as streaking. Four pages print: A text page with printer information, cartridge information, current margin settings, and a graphic. Three pages all gray, all black, and the last one blank. Cartridge lockout function is disabled. None Edge to Edge Allow a shift of all four margins (top, bottom, right, and left) to the physical edge of the page (printable area of supported paper). Setting is ignored by PPDS interpreter. Off (default) On Defaults Change sizes and designations to metric. U.S. (default) Non-U.S. Cont Prt Simplex Tray 1 Continuously print pages containing cross lines, printer information, and margin settings. Press and hold until the lights flash to begin. Press to stop. None Cont Prt Duplex Tray 1 Continuously print pages containing cross lines, printer information, and margin settings. Press and hold until the lights flash to begin. Press to stop. None Cont Prt Simplex Tray 2 Continuously print pages containing cross lines, printer information, and margin settings. Press and hold until the lights flash to begin. Press to stop. None Cont Prt Duplex Tray 2 Continuously print pages containing cross lines, printer information, and margin settings. Press and hold until the lights flash to begin. Press to stop. None Print History Print history of errors. Press and hold until the lights flash to print. None Configuration ID Allow the printer ID to match the label ID after the controller board is replaced. 000101 (default) 000189 Printer alignment Align a new printhead. See "Printhead assembly mechanical adjustment" on None page 3-9 for more information. 3-8 Lexmark™ E260d, E260dn