Lexmark MX610 Card Stock & Label Guide - Page 117
Select the Paper Texture setting., delaminating, oozing around the edges
View all Lexmark MX610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Printer specifications 117 Overview of card stock and label support Paper source Standard tray Index Bristol - Card Stock Tag - Optional 250‑sheet tray - Optional 550‑sheet tray Manual feeder Multipurpose feeder 163 g/m2 Card stock should be grain short and set to exit the rear door. - 163 g/m2 For paper and transparency specifications, see the printer publications CD. Cover - - - Labels Paper 90 g/m2 90 g/m2 90 g/m2 Media specifications Labels Width: 210-216 mm (8.3-8.5 in.) Length: 279-297 mm (11-11.7 in.) Weight: Up to 90 g/m2 (24 lb) Thickness: Up to 0.25 mm (0.01 in.) Smoothness: 100-300* Sheffield *150-200 Sheffield is optimal. Using media higher than 300 Sheffield could result in printing degradation. Card stock Weight: Up to 163 g/m2 Index Bristol (90 lb) Up to 163 g/m2 Tag (100 lb) Note: To minimize curl, use the rear exit when printing on card stock and labels. When printing on labels: • Check with the manufacturer or vendor to ensure the labels can withstand temperatures up to 210°C (410°F) without sealing, curling excessively, wrinkling, or releasing hazardous emissions. • Check with the manufacturer or vendor to ensure the labels can withstand 25 psi (172 kPa) pressure without delaminating, oozing around the edges, or releasing hazardous fumes. • Do not use labels with slick backing material. • Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. • Do not use labels with exposed adhesive. • Do not print within 1 mm (0.04 in.) of the edge of the label, of the perforations, or between die‑cuts on the label. • Be sure adhesive backing does not reach to the sheet edge. Zone coating of the adhesive at least 1 mm (0.04 in.) away from the edges is recommended. Adhesive material contaminates the printer and could void the warranty. • If zone coating of the adhesive is not possible, remove a 1.6 mm (0.06 in.) strip on the leading and driver edge, and use a non‑oozing adhesive. • Portrait orientation works best, especially when printing bar codes. When printing on card stock: • Make sure the Paper Type is Card Stock. • Select the Paper Texture setting.