Lexmark MX611 User's Guide - Page 269

Troubleshooting 269 Printer had to restart. Last job may be incomplete. From the printer control panel, touch Continue to clear the message and continue printing. For more information, visit http://support.lexmark.com or contact customer support. Remove defective disk [61] Remove and replace the defective printer hard disk. Remove paper from standard output bin Remove the paper stack from the standard bin. Replace defective imaging unit [31.xy] Replace the defective imaging unit to clear the message. For more information, see the instruction sheet that came with the supply. Note: If you do not have a replacement imaging unit, then see the "Ordering supplies" section of the User's Guide or visit www.lexmark.com. Replace cartridge, 0 estimated pages remain [88.xy] Replace the toner cartridge. For more information, see the instruction sheet that came with the supply. Note: If you do not have a replacement toner cartridge, then see the "Ordering supplies" section of the User's Guide. Replace imaging unit, 0 estimated pages remain [84.xy] Replace the imaging unit. For more information, see the instruction sheet that came with the supply. Replace maintenance kit, 0 estimated pages remain [80.xy] Contact customer support at http://support.lexmark.com or your service representative, and then report the message. The printer is scheduled for maintenance. Replace all originals if restarting job. Try one or more of the following: • Touch Cancel job to clear the message and cancel the scan job. • Touch Scan from automatic feeder to continue scanning from the ADF immediately after the last successful scan job. • Touch Scan from flatbed to continue scanning from the scanner immediately after the last successful scan job. • Touch Finish job without further scanning to end the last successful scan job. • Touch Restart job to restart the scan job with the same settings from the previous scan job.