Lexmark MX6500e 6500e IPDS Printer and Host Setup Guide - Page 34

IPDS Printer and Host Setup Guide Printer Messages and Problems PSF/MVS PSF Startup Proc: Disconnect Interval (DISCINTV) PSF/2 TCP/IP Settings: Connect Timeout Tuning Option: Job Interval Shutdown Timer PSF/AIX SMIT Printer Def: Connect Timeout 15 seconds 30 seconds 30 seconds 30 seconds IPDS Timeout = 15 seconds to 10 minutes If you selected an IPDS Timeout value of 15 seconds to 10 minutes in order to allow the printer IPDS emulation to determine when an IPDS LAN session times out, correct the appropriate host timer/timeout value as shown below. PSF/400 with OS/400 V3R1 or V3R6 WRKAFP2: Inactivity Timer (INACTTMR) PSF/400 with OS/400 V3R2, V3R7, V4R1-R5, V5R1-R4, V6R1, or greater CRTPSFCFG: Release Timer (RLSTMR) PSF/MVS PSF Startup Proc: Disconnect Interval (DISCINTV) PSF/2 TCP/IP Settings: Connect Timeout Tuning Option: Job Interval Shutdown Timer PSF/AIX SMIT Printer Def: Connect Timeout *NOMAX *NOMAX 0 0 9999 0 Problem 4: IPDS memory exception Sometimes an IPDS memory exception is reported to the host. Solution to Problem 4 You need to do one or more of the following: A. Postscript or PCL resources may be saved in the printer memory. The memory cannot be used by IPDS. Set Resource Save to "Off" in the printer menu to allow permanent downloaded resources from PostScript and PCL jobs to be deleted. Try reprinting the job after powering the printer OFF and ON. B. There may be insufficient printer memory to print the IPDS job with print resolution selected in the printer's MENU/Menus > Option Card Menu > IPDS MENU > EMULATION >IPDS Print Res menu item. Select a lower print resolution and try reprinting the job. C. There may be insufficient printer memory to temporarily store IPDS resources and print non-IPDS jobs. Add more memory to the printer. Requirements vary greatly according to type of printing and types of resources being used. For information on the minimum recommended installed memory for various printing 34