Lexmark P6260 Setup Sheet - Page 1

6200 Series All-In-One *21B0070* Safety Information • Use only the power supply provided with this product or the manufacturer's authorized replacement power supply. • Connect the power supply cord to an electrical outlet that is near the product and easily accessible. • Refer service or repairs, other than those described in the user documentation, to a professional service person. CAUTION: Do not use the fax feature during a lightning storm. Do not set up this product or make any electrical or cabling connections, such as the power supply cord or telephone, during a lightning storm. 1Unpack your All-In-One Note: Contents may vary. 3 Load paper 1 2 Lift the paper support and extend the paper exit tray. Load plain paper. 3 Lower the paper feed guard, squeeze the paper guide, and slide it to the left edge of the paper. 3 2 2 Prepare your All-In-One 1 Connect the power cord. 2 3 Make sure the Power light is Press the right arrow button to scroll to your language, on. and then press Select . 2 1 2 1 4 Prepare the print cartridges 1 Remove the photo cartridge from the print cartridge storage unit. 2 Remove the sticker and tape from the print cartridges. 1 1 2 2 1 Warning: Do not touch the copper contact area on the back or the metal print cartridge nozzles on the bottom. 5 Install the print cartridges 1 Lift the scanner unit. 2 3 Open the cartridge lids, insert the cartridges, and snap the lids closed. Close the scanner unit. Left: Right: 1 4 Press Select to print an alignment page. Cartridge storage 1 Keep a new or partially used cartridge in the print cartridge storage unit: 2 Place the stored cartridge in the storage area of your All-In-One. 1 2 3 3 2 You may discard the alignment page after it prints. If you are using your All-In-One with a computer, continue with "Install the software"... Lexmark Confidential until announced