Lexmark T522 Service Manual - Page 156

4520-xxx Print Test with RIP (Controller Board) Removed This service mode lets you test and service the printer without the controller board installed. You can verify that the motors, sensors, printhead and EP process are working correctly. You can also make meter measurements on the engine board connectors with the controller board removed. The test page consists of horizontal lines spaced approximately one inch apart down the page. To run the test: 1. Turn the printer off. 2. Remove the controller board and inner shield. 3. Turn the printer on. 4. Press Select to start the test after Start Print Test displays. The test is continuous. 5. Press Select once again to stop the test. Printing Menu Settings Page Note: This test page must be printed on letter, legal or A4 paper. To print the Menu Settings Page: 1. Select the TESTS MENU. 2. Select Print Menus from the TESTS MENU. The page contains the following information: • A list of all the printer settings contained in the operator panel menus and their values. • A list of the installed options and features such as RAM memory cards, optional input paper trays, envelope feeder, duplex unit, output bins, flash or disk. • Printer information such as serial number, page count, installed RAM, engine code level, RIP code level, envelope feeder code level, tray 1-5 code levels, output bin 1-3 code levels, operator panel code levels, font ROM version and SRAM availability. 3-24 Service Manual