Lexmark T650 Service Manual - Page 150
A recoverable MVRAM Cyclic, Redundancy Check CRC - reset chip
View all Lexmark T650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
4062 Error code or message 949.00 Error contents System card failure 950.xx NVRAM mismatch failure 952.xx NVRAM failure 953.xx NVRAM failure Description/Action Possible repair actions Delay line calibration failure. Mismatch between system card EEPROM and operator panel mirror. ".xx" codes: 00-29: mismatch between system and mirror 30-60: mismatch between secure and system A recoverable MVRAM Cyclic Redundancy Check (CRC) error occurred. The NVRAM chip has failed on the operator panel door assembly. Replace the system card assembly. Go to "System card assembly removal (T650, T652, T654, T656)" on page 4-76. Warning: When replacing any of the following components: • Operator panel assembly • System card assembly Only replace one component at a time. Replace the required component and perform a POR before replacing a second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never replace two or more of the components listed above without a POR after installing each one or the printer will be rendered inoperable. Never install and remove components listed above as a method of troubleshooting components. Once a component has been installed in a machine, it can not be used in another machine. It must be returned to the manufacturer. Go to NVRAM mismatch failure service check. See "NVRAM mismatch failure (950.00 through 950.29) service check" on page 2-155. Power the machine off/on to reset the error condition. Replace the operator panel door assembly. Go to "Operator panel door assembly removal (T650, T652, T654)" on page 4-44. If problem remains, replace the fuser unit assembly. Go to "Fuser unit assembly removal (T650, T652, T654)" on page 4-23. 2-116 Service Manual