Lexmark T652 Service Manual - Page 116
Lexmark T652 Manual
View all Lexmark T652 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
4062 Error code or message 28x.69 x = bin number Error contents Description/Action Possible repair actions Staple ready home position jam Applies to: StapleSmart finisher The sensor (self priming) within the stapler assembly does not detect a ready staple in the specified time after the staple job was sent. Staples not empty 1. Check all the connections on the controller card and the stapler assembly. 2. Remove the staple cartridge and remove all jammed staples. If the cartridge is jammed and can not be removed, go to step 3. 3. Remove the stapler assembly. Go to "SFP stapler assembly stapler unit assembly removal" on page 4-182. 4. Manually rotate the drive gears and reset the stapler. Remove all jammed staples then reinstall the stapler assembly. 5. If problem remains, replace the stapler assembly. Go to "SFP stapler assembly stapler unit assembly removal" on page 4-182. 28x.70 x = bin number Stapler mechanism not in home position failure Applies to: StapleSmart finisher The sensor (home signal) within the stapler assembly detected that the stapler mechanism was not in the home position before stapling. 1. Check all the connections on the controller card and the stapler assembly. 2. Remove the staple cartridge and remove all jammed staples. If the cartridge is jammed and can not be removed, go to step 3. 3. Remove the stapler assembly. Go to "SFP stapler assembly stapler unit assembly removal" on page 4-182. 4. Manually rotate the drive gears and reset the stapler and remove all jammed staples then reinstall the stapler assembly. 5. If problem remains, replace the stapler assembly. Go to "SFP stapler assembly stapler unit assembly removal" on page 4-182. 2-82 Service Manual