Lexmark XC9465 Users Guide - Page 491
Japanese telecom notice, Lexmark International, Inc., LEX-M14-002
View all Lexmark XC9465 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 491 highlights
Notices 491 This equipment is not capable, under all operating conditions, of correct operation at the higher speeds for which it is designed. Spark will accept no responsibility should difficulties arise in such circumstances. The decadic (or pulse) dialing on this device is unsuitable for use on the Spark network in New Zealand. For correct operation, the total of all the Ringer Equivalence Numbers (RENs) of all parallel devices connected to the same telephone line may not exceed 5. The REN of this device is located on the label. This device uses an RJ-11C modular connector. Contact your point of purchase if a BT adapter is required. The Lexmark part number is 80D1873. Some parameters required for compliance with Spark's telepermit requirements are dependent on the equipment associated with this device. The associated equipment shall be set to operate within the following limits for compliance to Spark's specifications: • There shall be no more than 10 call attempts to the same number within any 30 minute period for any single manual call initiation, and • The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt and the beginning of the next call attempt. • The equipment shall be set to ensure that automatic calls to different numbers are spaced such that there is not less than 5 seconds between the end of one call attempt and the beginning of another. Japanese telecom notice The installed optional modem is in compliance with Japanese Telecommunication Law and has been Certified by JATE, with the following Certification Number: A18-0046001 Lexmark International, Inc. LEX-M14-002 A18-0046001 Using this product in Switzerland This product requires a Swiss billing tone filter (Lexmark part number 80D1877) to be installed on any line which receives metering pulses in Switzerland. Utilisation de ce produit en Suisse Cet appareil nécessite l'utilisation d'un filtre de tonalité de facturation suisse (nº de référence Lexmark : 80D1877) devant être installé sur toute ligne recevant des impulsions de comptage en Suisse.