LiftMaster 3595 3595 Elite Series Manual - Page 19

INSTALLATION STEP 12 Connect Door Arm to Trolley Inner Trolley SECTIONAL DOORS ONLY • Make sure garage door is fully closed. Pull the emergency release handle to disconnect the outer trolley from the inner trolley. Slide the outer trolley back (away from the door) about 2" (5 cm) as shown in Figures 1, 2 and 3. • Figure 1: - Fasten straight door arm section to outer trolley with the 5/16"x1" clevis pin. Secure the connection with a ring fastener. - Fasten curved section to the door bracket in the same way, using the 5/16"x1-1/4" clevis pin. • Figure 2: - Bring arm sections together. Find two pairs of holes that line up and join sections. Select holes as far apart as possible to increase door arm rigidity. • Figure 3, Hole alignment alternative: - If holes in curved arm are above holes in straight arm, disconnect straight arm. Cut about 6" (15 cm) from the solid end. Reconnect to trolley with cut end down as shown. - Bring arm sections together. - Find two pairs of holes that line up and join with bolts, lock washers and nuts. • Proceed to Adjustment Step 1, page 20. Trolley will re-engage automatically when opener is operated. Figure 1 HARDWARE SHOWN ACTUAL SIZE Figure 2 Outer Trolley Ring Fastener Clevis Pin 5/16"x1" Door Bracket Straight Door Arm Curved Door Arm Clevis Pin 5/16"x1-1/4" Lock Washers 5/16" Nuts 5/16"-18 Door Bracket Emergency Release Handle Bolts 5/16"-18x7/8" Nut 5/16"-18 Lock Washer 5/16" Ring Fastener Clevis Pin 5/16"x1" (Trolley) Clevis Pin Hex Bolt 5/16"x1-1/4" (Door Bracket) 5/16"-18x7/8" Lock Washers 5/16" Nuts 5/16"-18 Figure 3 Bolts 5/16"-18x7/8" Cut This End 19