LiftMaster 81600MC Users Guide - English French - Page 10
The Protector System® (Safety Reversing Sensors), Light Beam Protection Area
View all LiftMaster 81600MC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Operation The Protector System®(Safety Reversing Sensors) Be sure power is NOT connected to the garage door opener BEFORE installing the safety reversing sensor. To prevent SERIOUS INJURY or DEATH from closing garage door: • Correctly connect and align the safety reversing sensor. This required safety device MUST NOT be disabled. • Install the safety reversing sensor so beam is NO HIGHER than 6" (15 cm) above garage floor. The door will not close if the sensors have not been installed and aligned correctly. When the light beam is obstructed or misaligned while the door is closing, the door will reverse. If the door is already open, it will not close. The sensors can be aligned by loosening the wing nuts, aligning the sensors, and tightening the wing nuts. Check to make sure the LEDs in both sensors are glowing steadily. The LEDs in both sensors will glow steadily if they are aligned and wired correctly. Wing Nut Light Beam Protection Area Wing Nut Sending sensor - amber LED 6" (15 cm) max. above floor Receiving sensor - green LED 6" (15 cm) max. above floor Receiving sensor has a sticker on the back. If either of the sensor LEDs are off, there is no power to the sensor: 1. Check that you have power to the garage door opener. 2. Check the sensor wire is not shorted or broken. 3. Check that the sensors are wired correctly; white wires to white terminal and white/black wires to grey terminal. If the green receiving sensor LED is blinking, the sensors are obstructed or misaligned: 1. Check for obstructions in the sensor light beam. 2. Align the sensors. 3. If the receiving sensor (green LED) faces direct sunlight, switch the sensors to opposite sides of the door to assure proper operation. 10