LiftMaster 8360 8360 Chain Drive Garage Door Opener Manual - Page 31
Door Control (Cont.), Activate, Temporarily hold door open suspend TTC, LIGHT FEATURE
View all LiftMaster 8360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Door Control TIMER-TO-CLOSE (TTC) (881LM ONLY) NOTE: DO NOT enable TTC if operating a one-piece door. TTC is to be used ONLY sectional doors. Activate: Press and hold the ON button until one of the TTC LEDs light up. Then press the ON button again to cycle through the time interval options (the corresponding TTC LED will light for each time interval). The garage door opener light bulbs will blink as confirmation. Deactivate: Press and hold the OFF button until all TTC LEDs turn off and a beep is heard from the motor unit. Temporarily hold door open (suspend TTC): Press and release the HOLD OPEN button. Press the HOLD OPEN button again to resume normal TTC operation. 1 Minute TTC LED 5 Minute TTC LED 10 Minute TTC LED ON Button OFF Button HOLD OPEN Button LOCK Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as long as the lock feature is activated and your handheld remote control will not operate your garage door at this time. Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will stop flashing and normal operation will resume. Command LED LOCK Button LIGHT To change the amount of time the garage door opener lights will stay on: Press and hold the LOCK button until the garage door opener lights flash.* The time interval is indicated by the number of flashes. Number of times garage door opener lights flash Times the garage door opener light stays on 1 1 1/2 Minutes 2 2 1/2 Minutes 3 3 1/2 Minutes 4 4 1/2 Minutes To cycle through the time interval repeat the step above. LIGHT FEATURE Deactivate: Press and hold the LIGHT button until the garage door opener lights turn on, then off again.* Activate: Start with the garage door opener lights on. Press and hold the LIGHT button until the garage door opener lights turn off, then on again.* NOTE: If the command LED is continuously blinking, the LOCK feature needs to be deactivated. Command LED LOCK Button LIGHT Button * Approximately 10 seconds MOTION SENSOR Activate/Deactivate: Slide the motion sensor switch ON or OFF. Motion Sensor Switch Motion Sensor MAINTENANCE ALERT SYSTEM (MAS): Activate/Deactivate Press and hold the LEARN button. Then press the LIGHT button. The service LED will flash the status; Active is 2 flashes and deactivated is 3 flashes. Service LED LEARN Button LIGHT Button 31