LiftMaster 8360WLB Owners Manual - Page 40

Operation Using the Motion Detecting Control Panel LOCK Your remote controls will NOT work when LOCK mode is active however your keyless entry will still allow access to your garage. Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as long as the lock feature is activated and your handheld remote control will not operate your door at this time. Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will stop flashing and normal operation will resume. Command LED LOCK Button LIGHT To change the amount of time the garage door opener lights will stay on: Press and hold the LOCK button until the garage door opener lights flash.* The time interval is indicated by the number of flashes. Number of times garage door opener lights flash 1 2 3 4 Time the garage door opener light stays on 1-1/2 Minutes 2-1/2 Minutes 3-1/2 Minutes 4-1/2 Minutes To cycle through the time intervals repeat the step above. * Approximately 10 seconds LIGHT FEATURE (Default is Active) Deactivate: Press and hold the LIGHT button until the garage door opener lights turn on, then off again.* Activate: Start with the garage door opener lights on. Press and hold the LIGHT button until the garage door opener lights turn off, then on again.* If the command LED is continuously blinking, the LOCK feature needs to be deactivated. MOTION SENSOR (Premium Motion-Detecting Control Panel) Activate/Deactivate: Slide the motion sensor switch ON or OFF. LOCK Button LIGHT Button Command LED Motion Sensor Switch MAINTENANCE ALERT SYSTEM (MAS): Activate/Deactivate: Press and hold the LEARN button. Then press the LIGHT button. The service LED will flash the status; Active is 2 flashes and deactivated is 3 flashes. Motion Sensor Service LED LEARN Button LIGHT Button 40