LiftMaster J GT- Logic 4 Installation Manual - Page 19
The installation surface must be smooth and flat.
View all LiftMaster J manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
NING CONTROL STATION WARNING ON WARNING To prevent possible SERIOUS INJURY or DEATH from electrocution: • Be sure power is NOT connected BEFORE installing door control. To prevent possible SERIOUS INJURY or DEATH from a closing door: • Install door control within sight of door, out of reach of children at a minimum height of 5 feet (1.5 m) and away from ALL moving parts of door. • Install the entrapment warning placard on wall next to the control station in a prominent location that is visible from the door. • NEVER permit children to operate or play with door control push buttons or remote controls. • Activate door ONLY when it can be seen clearly, is properly adjusted and there are no obstructions to door travel. • ALWAYS keep door in sight until completely closed. NEVER permit anyone to cross path of closing door. • Install the control station far enough from the door to prevent the user from coming in contact with the door while operating the controls. SEMENT AVERTISSEMENT ION 3 NOTE: The low voltage control circuit wiring requires insulated, 20 AWG or greater wire. Refer to back page for additional control Select appropriate knockout and run the wires to the operator. wiring. 1 Remove the control station cover. AVERTISSEMENT Connect wires to the control station and replace the control 4 station cover. 2 Fasten the control station to the wall at least 5 feet above the ground. The installation surface must be smooth and flat. Attach the MAS label to the side of the control station. 5 Fasten the entrapment warning placard next to the control station. ENCIA CIÓN 3 5' 5 1 2 4 24VAC 14 24VAC DATA 13 TIMER ^OPEN DEFEAT 12 ^ CLOSE O COMMON 11 STOP 24VAC POWER 24VAC TIMER DEFEAT MAS 10 COMMON MAS LMEP 9 LMEP: TIMER NABLE EDGE: OPEN EDGE 8 CLOSE OPEN ADVERTSTOP ENCIA 7 COMMON CLOSE 6 N STOP 5 ADVERTENCIA SBC COMMON 4 UL Entrapment Placard WARNING 3 2 SBC 1 3-Button Station OPEN CLOSE STOP Maintenance Alert LED (RD) (WH) Open Close Stop Moving Door Can Cause Serious Injury or Death Keep Clear! Door May Move at any Time Without Prior Warning Do Not Let Children Operate the Door or Play in the Door Area Keep Door in Sight at all Times When Door is Moving MAS Label Maintenance Alert SystemTM If light is Flashing Rapidly, it is time for routine door maintenance. If light is Flashing Slowly, followed by a pause, call for immediate service. WIRING 3-PHASE 1 PHASE Service every cycles/months 19 Wiring - Control station