LiftMaster MATDCBB3 MEGA ARM / MEGA ARM TOWER Manual - Page 18

ADDITIONAL FEATURES » TRAP INSTRUCTIONS TRAP INSTRUCTIONS INSTALL THE K1 AUXILIARY RELAY AND CONNECTOR AT MEGA ARM CONNECTED TO THE ACCESS DEVICE 1. Press the relay into the K1 location ensuring the pins are properly aligned. 2. Press the connector into the J1 connector pins. INSTALL THE K1 AUXILIARY RELAY AND CONNECTOR AT THE SECOND 1. Press the relay into the K1 location ensuring the pins are properly aligned. 2. Press the connector into the J1 connector pins. WIRE THE CONNECTIONS BETWEEN THE OPERATORS 1. Connect the Normally open output (NO) of the K1 relay on the trap operator to the OPEN input (J5 - term#2) of the second operator. 2. Connect the common output (C) of the K1 relay of the trap operator to the common of the second operator (J5 - term#12). 3. Connect the Normally open output (NO) of the K1 relay on the second operator to the INTERLOCK input of the trap operator (J5 - term#8). 4. Connect the common output (C) (J5 - term#12) of the second operator to the common of the trap operator (J5 - term#12). SET THE DIP SWITCHES AT THE TRAP OPERATOR 1. Set switch bank S1 to 00100001 where 1 is up and 0 is down. 2. Set switch bank S2 to 00100010 where 1 is up and 0 is down. RECONNECT THE POWER AND TEST 1. Reconnect the DC power by replacing the neutral (Black) wire to the battery terminal. 2. Reconnect the AC Power to the operator. 3. To test, activate the following sequence of inputs: • Open the trap gate using the access device. • When the trap gate is open, activate the close loop on the trap operator. The trap gate will close and the second gate should open. • When the second gate is open, activate the close loop on the second operator. The second gate should close. TRAP SET UP Interlock C TES S1-6 OFF S1-8 ON OPEN Trap MA C NC NO DC K1 S1-6 OFF S1-8 OFF MA Opener Common SET THE DIP SWITCHES AT THE SECOND OPERATOR 1. Set switch bank S1 to 00100000 where 1 is up and 0 is down. 2. Set switch bank S2 to 00100010 where 1 is up and 0 is down. C NC NO DC SS11 Trap Operator ON ON ON ON ON ON ON OFF OFF 1 2345678 SS22 ON ON ON ON ON ON ON OFF OFF 12345678 TRAP CONFIGURATION Must use trap kit. See Mega Arm Options Parts List Close Loop Trap Close Loop Trap Close Loop Close Loop Card Reader Tele-entry Radio Control Mega Arm Trap Mega Arm SS11 Mega ARM Operator ON ON ON ON ON ON ON ON OFF 12345678 SS22 ON ON ON ON ON ON ON OFF OFF 12345678 18