LiftMaster MEGA SLIDE MEGA SLIDE - MSLDCBB Manual - Page 10
Wiring And Hookup - wiring diagram
View all LiftMaster MEGA SLIDE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
W I R IWN GARANNIDNGH O O K U P WARNING ENT To reduce the risk of SEVERE INJURY or DEATH: • DO NOT install ANY wiring or attempt to run the operator • ANY maintenance to the operator or in the area near the operator MUST not be performed until disconnecting the electrical power and locking-out the power via the operator without consulting the wiring diagram. We recommend that you Install an optional reversing edge BEFORE proceeding with the control station installation. power switch. Upon completion of maintenance the area • ALL power wiring should be on a dedicated circuit and well MUST be cleared and secured, at that time the unit may be protected. The location of the power disconnect should be returned to service. visible and clearly labeled. • Disconnecting power at the fuse box BEFORE proceeding. • ALL power and control wiring MUST be run in separate Operator MUST be properly grounded and connected in conduit. accordance with local electrical codes. NOTE: The operator should be on a separate fused line of adequate capacity. • BEFORE installing power wiring or control stations be sure to follow ALL specifications and warnings described below. AVERTISSEMENT • ALL electrical connections MUST be made by a qualified individual. Failure to do so may result in SEVERE INJURY to persons and/or damage to operator. AVERTISSEMENT AC POWER HOOKUP (120/230 Vac) Be sure your main power is OFF before attempting to hook up the ac power. The ac wiring should be attached to the wires exiting the conduit or pedestal post. Only use UL approved 14AWG (or larger) 600 volt insulated wire. NOTE: Do not connect any of the ac power wires directly to the electronic control board. Connect the batteries after the ac power is restored. 120 Vac Connect the BLACK wire to the incoming 120 Vac hot lead and connect the WHITE wire to the incoming neutral lead. Connect the GREEN wire to the ground. 230 Vac Please purchase the 120 to 230 Vac conversion kit for 230 Vac operation. See Accessory page. CIA N Duplex Outlet Box 120 Vac Hot (Black) Ground (Green) Neutral (White) Neutral ADVERTENCIA Ground 120 Vac ADVERTENCIA 10