LiftMaster PPLV1-10 Passport Lite Remote Control Owners Manual - Page 2

THE REMOTE CONTROL BATTERY To replace battery, open the case as shown. Insert battery positive side up (+). Replace the battery with only 3V CR2032 coin cell battery. Dispose of old battery properly. VISOR REMOTE Pry open the case first in the middle (1), then at each side (2 and 3) with the visor clip. KEY CHAIN REMOTE Pry open the case with a screwdriver blade. Battery Battery To prevent possible SERIOUS INJURY or DEATH: • NEVER allow small children near batteries. • If battery is swallowed, immediately notify doctor. To reduce risk of fire, explosion or chemical burn: • Replace ONLY with 3V CR2032 coin batteries. • DO NOT recharge, disassemble, heat above 212° F (100° C) or incinerate. NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 3 1 2 REPLACEMENT PARTS 3V CR2032 Lithium battery 10A20 Visor Clip 29B137 ONE YEAR LIMITED WARRANTY The Chamberlain Group, Inc. warrants to the first consumer purchaser of this product that it is free from defect in materials and/or workmanship for a period of 1 year from the date of purchase. 114A4494C © 2014, The Chamberlain Group, Inc. All Rights Reserved 1-800-528-9131 www.liftmaster.com