LiftMaster TAC2D TAC2C Programming Guide Manual - Page 7
Resident Instructions For Tac Models, Direct Commands From The Local Telephone
View all LiftMaster TAC2D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
PROGRAMMING » RESIDENT INSTRUCTIONS FOR TAC MODELS DIRECT COMMANDS FROM THE LOCAL TELEPHONE Direct commands allow you to control the unit from the resident telephone. To use direct commands lift the handset, wait for dial tone and enter the direct command. PROGRAMMING NUMBER *5 *9 **04 **05 **11 **12 DESCRIPTION OF TASK Triggers Relay 2 Triggers Relay 1 Enable Party (Latched) Mode Relay 1 Disable Party (Latched) Mode Relay 1 Enable "Do Not Disturb" Mode Disable "Do Not Disturb" Mode FACTORY SETTING PROGRAMMING PROCEDURE *5 *9 **04 Disabled **11 **12 ANSWERING A CALL FROM A VISITOR To answer a call lift the handset. To control the gate press "*9" or "*5". ANSWERING CALLS FROM A REMOTE TELEPHONE When a call is answered from a remote telephone a beep will be heard for 10 seconds. To accept the call press "0". Hang up to disconnect. To control the gate press "*9" or "*5". PROGRAMMING NUMBER 0 *5 *9 DESCRIPTION OF TASK Accepts Call From The Unit (Also Extends Talk Time) Triggers Relay 2 Triggers Relay 1 FACTORY SETTING PROGRAMMING PROCEDURE 0 *5 *9 NOTE: Use the STAR Key "*" to cancel any input. NOTE: Keypad commands are to be entered in a single string to result in success (indicated by double high success tone). Stop and go keystrokes will result in negative tones (low single and triple fail tones). 7