Linksys EG008W User Guide - Page 8

The Back Panel, Ports - 10 100 1000mbps gigabit workgroup switch

Get Linksys EG008W - Instant Gigabit Workgroup Switch PDF manuals and user guides
UPC - 745883554058
View all Linksys EG008W manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

Gigabit 8-Port Workgroup Switch The Back Panel The ports are located on the back panel of the Switch. Ports 10/100/1000 ETHERNET 1-8 Power Figure 2-2: Back Panel The Switch is equipped with eight auto-sensing, Ethernet network ports, which use RJ-45 connectors. These ports support auto MDI/MDIX cable detection and network speeds of 10Mbps, 100Mbps, and 1000Mbps. They can operate in half and full-duplex modes. Autosensing technology enables each port to automatically detect the speed of the device connected to it (10Mbps, 100Mbps, or 1000Mbps), and adjust its speed and duplex accordingly. The Power port is where you will connect the included power adapter. NOTE: If you need to reset the Switch, unplug the power adapter from the back of the Switch. Wait a few seconds and then reconnect it. Chapter 2: Getting to Know the Switch 4 The Back Panel

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
4
Chapter 2: Getting to Know the Switch
The Back Panel
Gigabit 8-Port Workgroup Switch
The Back Panel
The ports are located on the back panel of the Switch.
Ports
10/100/1000
ETHERNET 1-8
The Switch is equipped with eight auto-sensing, Ethernet network ports, which use RJ-45
connectors. These ports support auto MDI/MDIX cable detection and network speeds of
10Mbps, 100Mbps, and 1000Mbps. They can operate in half and full-duplex modes. Auto-
sensing technology enables each port to automatically detect the speed of the device
connected to it (10Mbps, 100Mbps, or 1000Mbps), and adjust its speed and duplex
accordingly.
Power
The
Power
port is where you will connect the included power adapter.
NOTE:
If you need to reset the Switch, unplug the power adapter from the
back of the Switch. Wait a few seconds and then reconnect it.
Figure 2-2: Back Panel