Logitech HARMONY1000 User Manual - Page 16

User Manual Harmony 1000 Adding the RF Wireless Extender to the Z-Wave Network Any time you update the remote, you must add the RF Wireless Extender to your Z-Wave network again. To add the extender to your Z-Wave network: 1. Take your remote to the RF Wireless Extender you want to add. Make sure the extender is plugged into a power outlet. 2. Press Add on the remote when you see a message reminding you to add an RF Wireless Extender to your network. 3. Press Connect on the RF Wireless Extender. By pressing Connect you will add the extender to your Z-Wave network. Assigning Devices to the Harmony Remote and the RF Wireless Extender You can assign either the Harmony Remote or the RF Wireless Extender to control your devices. Controlling a Device With the RF Wireless Extender: If you have set the RF Wireless Extender to control a device, the remote will send RF (radio frequency) signals (see A) to the RF Extender, which will then convert the signals to IR and send the signals to the device. Controlling devices using the RF Extender means you can control the devices even if they are behind closed doors (e.g. a cabinet) or in a different room (see B and C). Controlling a Device With the Remote: If you have set the remote to control a device, the remote will use IR (infrared) signals to control the device. In order for the remote to control the device, there must be a direct line of sight between the signal sent by the remote and the device receiving the signal (see A). v. 1.2 page 14