Logitech Z-5500 Digital 51 User's Guide - Page 3
Important - z digital 5 1 ch
View all Logitech Z-5500 Digital 51 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Digital SoundTouch™ Control Center & Remote Control Important: For your safety, set up the entire system before plugging it into a power source. To setup your system, see the Quick Start guide. SoundTouch™ Control Center Overview 1. Digital LCD 2. Input: Use to select audio source (optical, coax, 6 ch. Direct or Stereo 1-3) 3. Effect: Use to select sound effect (Stereo, Stereo x2, Pro Logic, etc.) 1 4 3 2 4. Settings: Adjust parameters of digital surround sound effects 5. Mute: Mute the system 6. Level: Use to select subwoofer, center, rear or main volume 7. Pro-audio style knob: Adjusts volume, subwoofer, center, and other levels 8. System Power: Toggles between Ready and Standby modes input effect settings level mute 5 6 7 8 Remote Control All functions are available on the remote control 1. Direct: Select Direct Input source (when in Stereo 1-3, this button will cycle through Direct 1, Direct 2, and Direct 3 stereo inputs) 2. Optical: Select Optical Input source 3. Coax: Select Coax Input source 4. Effect: Select sound effect 2 12 1 5. Settings: Adjusts parameters of digital surround sound effects 9 6. Mute: Mute the system 8 7. Volume up/down: Adjusts main volume 8. Sub up/down: Adjust subwoofer level 6 9. Center up/down: Adjust center level 10. Surround up/down: Adjust surround (rear) level 11. System Power 12. Test: The Test State is only available from the remote. 3 See the section on "Test State" for a full description of this mode. English center surround sub 11 3 5 4 10 7 Important: For your safety, set up the entire system before plugging it into a power source. This information is also shown on the Quick Start guide. Initial Setup Overview: 1. Satellite speakers Before attaching the cables, position two satellite speakers on either side of your computer monitor or television about the same distance from each other as from you. Angle them to face you. Place the rear speakers behind you and about the same distance apart as the front speakers. You may want to mount these speakers on the wall. If so, simply rotate the stands 180°. Mount the speakers using appropriate wall anchors through the holes in the stands. For a pro-audio look, remove the cloth grilles by pulling them straight off. Removing the grilles will not affect sound quality. 2. Center channel Depending on your configuration, place your center channel speaker on your desk (angled up), on top of your monitor or television (angled down), or wall-mounted (angled down). To wall mount the speaker, remove the screw from side of neck, rotate stand and replace screw. Mount speaker using appropriate wall anchors through holes in stand. 3. Subwoofer Because bass frequencies are non-directional, the subwoofer can be placed anywhere in relation to the other speakers. To ensure optimum sound quality, do not block the driver or the bass port. To achieve the strongest bass, place the subwoofer near a wall, corner or under a desk. Note: Please ensure adequate ventilation around the subwoofer. Keep the cooling fins on the back of the subwoofer at least 6 inches away from any object. For your safety, the Z-5500 Digital system is protected by a thermal overload switch, which will cause the system to shut down if it becomes too hot. In rare circumstances where the ambient room temperature is high, the unit can shut down. If this occurs, turn off the system and allow it to cool. Increase the ventilation around the system before turning the power back on. 4. Digital SoundTouch™ Control Center Position the Digital SoundTouch™ Control Center where it is easy to reach. 5. With the power off and the speakers in place, connect the speaker wire to the spring clips on the satellites and to the corresponding spring clips on the subwoofer. To connect, push the tab on the spring clip, insert the wire into the connector, and release the tab. Make sure that you match the wire color to the spring clip colors on both the subwoofer and the satellite. 6. Use the remote control or the control pod to select an input source. 4 English Setup