Lowrance HDS-7 Gen2 Installation Manual - Page 30
Wiring the HDS
View all Lowrance HDS-7 Gen2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Wiring the HDS Wiring Guidelines Most installation problems are caused by shortcuts taken with system cables. When wiring the HDS follow the guidelines below. Don't do this Do this Don't make sharp bends in the cables Do make drip and service loops Don't run cables in a way that allows water Do tie-wrap all cables to keep them secure to flow down into the connectors Don't route the data cables in areas adjacent Do leave room at the back to install and to radar, transmitter, or large current remove cables carrying cables Before starting the installation, be sure to turn electrical power off. If power is left on or turned on during the installation, fire, electrical shock, or other serious injury may occur. Be sure that the voltage of the power supply is compatible with the HDS display. The HDS has a voltage rating of 10-19V DC. The red wire should always be connected to (+) DC V using a fuse or thermal breaker (10 Amp) 29